Kia Rio: Blower Resistor (MANUAL) Replacement
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Disconnect the connector (A) and then remove the blower resistor
(B) after loosening the mounting screws.
|
| 3. |
Install in the reverse order of removal.
|
Blower Resistor (MANUAL) Inspection
1.
Measure the resistance between the terminals.
2.
The measured resistance is not within specification, the blower
resistor must be replac ...
Power Mosfet (FATC) Inspection
1.
Turn the ignition switch ON.
2.
Manually operate the control switch and measure the voltage of
blower motor.
3.
...
See also:
Troubleshooting
Ignition System
Symptom
Suspect Area
Remedy
Engine will not start or is hard to
start (Cranks OK)
Ignition lock switch
Inspect igni ...
Components
[Front]
(5 Door, 4 Door)
1. Front seat belt
2. Height adjust
3. Front seat belt anchor pretensioner (NA : North america)
[Rear]
...
Categories
- Kia Rio Manuals Home
- Kia Rio YB 2017-2026 Owners Manual
- Kia Rio YB 2017-2026 Service Manual
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright www.kirmanual.com 2014-2026