Kia Rio: ESC OFF Switch Inspection - ESC(Electronic Stability Control) System - Brake System - Kia Rio UB 2012-2019 Service ManualKia Rio: ESC OFF Switch Inspection

1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the crash pad lower panel.
(Refer to the Body group - "Crash pad")
3.
Remove the crash pad side switch assembly (A).


4.
Check the continuity between the switch terminals as the ESC OFF switch is engaged.


ESC OFF Switch Description
1. The ESC OFF switch is for the user to turn off the ESC system. 2. The ESC OFF lamp is on when ESC OFF switch is engaged. ...

Steering Angle Sensor (MDPS Only) Description
The Steering Angle Sensor (SAS) is installed in MDPS (Motor Driven Power Steering) and it sends messages to HECU through CAN communication line. The SAS is used to determine turning directio ...

See also:

ECM Terminal And Input/Output signal [M/T]
ECM Terminal Function (M/T) Connector [EGGM-AG] Pin No. Description Connected to 1 Injector (Cylinder #3) [High] control output ...

Rear Coil Spring Replacement
1. Remove the rear wheel & tire. (Both RH side and LH side) Tightening torque : 88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb ...

Front Hub / Knuckle Replacement
1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) fro ...

Copyright © www.kirmanual.com 2014-2019