Kia Rio: Front Hub / Knuckle Disassembly - Front Axle Assembly - Driveshaft and axle - Kia Rio UB 2012-2020 Service ManualKia Rio: Front Hub / Knuckle Disassembly

1.
Remove the snap ring (A).


2.
Remove the hub assembly from the knuckle assembly.
(1)
Install the front knuckle assembly (A) on press.
(2)
Lay a suitable adapter (B) upon the hub assembly shaft.
(3)
Remove the hub assembly (C) from the knuckle assembly (A) by using press.


3.
Remove the hub bearing inner race from the hub assembly.
(1)
Install a suitable tool (A) for removing the hub bearing inner race on the hub assembly.
(2)
Lay the hub assembly and tool (A) upon a suitable adapter (B).
(3)
Lay a suitable adapter (C) upon the hub assembly shaft.
(4)
Remove the hub bearing inner race (D) from the hub assembly by using press.


4.
Remove the dust cover (A).


5.
Remove the hub bearing outer race from the knuckle assembly.
(1)
Lay the hub assembly (A) upon a suitable adapter (B).
(2)
Lay a suitable adapter (C) upon the hub bearing outer race.
(3)
Remove the hub bearing outer race from the knuckle assembly by using press.


6.
Replace hub bearing with a new one.
Front Hub / Knuckle Replacement
1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) fro ...

Front Hub / Knuckle Reassembly
1. Install the hub bearing to the knuckle assembly. (1) Lay the knuckle assembly (A) on press. (2) ...

See also:

Ignition Coil: Inspection
1. Measure the primary coil resistance between terminals (+) and (-). Standard value: 0.75Ω ± 15% ...

Air Outlet and Air Flow
The mode selection switch controls the direction of the air flow through the ventilation System Air Flow Symbol Outlet Description ...

Catalytic Converter
Description The catalytic converter of the gasoline engine is a three way catalyst. It oxidizes carbon monoxide and hydrocarbons (HC), and separates oxygen from the oxides of nitrogen (NOx). ...

Copyright © www.kirmanual.com 2014-2020