Kia Rio: Front Lower Arm Replacement - Front Suspension System - Suspension System - Kia Rio UB 2012-2020 Service ManualKia Rio: Front Lower Arm Replacement

1.
Remove the front wheel & tire.

Tightening torque :
88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)



     
Be careful not to damage to the hub bolts when removing the front wheel & tire.
2.
Loosen the nut and remove the lower arm (A).

Tightening torque :
58.8 ~ 70.6N.m(6.0 ~ 7.2kgf.m, 43.4 ~ 52.1lb-ft)


3.
Remove the lower arm (C) by loosening the bolt (A) and (B).

Tightening torque :
(A)
98.1 ~ 117.7N.m(10.0 ~ 12.0kgf.m, 72.3 ~ 86.8lb-ft)
(B)
156.9 ~ 176.5N.m(16.0 ~ 18.0kgf.m, 115.7 ~ 130.2lb-ft)


4.
Installation is the reverse of removal.
Front Strut Assembly Inspection
1. Check the components for damage or deformation. 2. Compress and extend the piston rod (A) and check that there is no abnormal resistance ...

Front Lower Arm Inspection
1. Check the bushing for wear and deterioration. 2. Check the lower arm for deformation. 3. Check the all bolts ...

See also:

Torque Converter Control Solenoid Valve (T/CON_VFS) Inspection
1. Turn ignition switch OFF. 2. Disconnect the solenoid valve connector. 3. Measure resistance between sensor ...

CVVT (Continuously Variable Valve Timing) System: [CVVT System Mode]
(1) Low Speed / Low Load (2) Part Load (3) Low Speed / High Load (4) High Speed / High Load ...

Basic Troubleshooting
Basic Troubleshooting Guide Customer Problem Analysis Sheet Basic Inspection Procedure Measuring Condition of Electronic Parts' Resistance The measured resistance at hig ...

Copyright © www.kirmanual.com 2014-2020