Kia Rio: Head lamp leveling Actuator Removal - Head lamp leveling Device - Body Electrical System - Kia Rio UB 2012-2024 Service ManualKia Rio: Head lamp leveling Actuator Removal

1.
Disconnect the negative (-) battery terminal.
2.
Remove the head lamp assembly (Refer to the head lamp).
3.
Remove the head lamp leveling actuator by turning the adjusting gear in the hole using the adjusting wheel or screw driver.
Circuit Diagram
...

Head lamp leveling Actuator Installation
1. Install the head lamp leveling actuator by turning the adjusting gear. 2. Install the head lamp assembly. 3. ...

See also:

Torque Converter Control Solenoid Valve (T/CON_VFS) Specifications
Direct control VFS[T/CON] ▷ Control type : Normal low type Control Pressure kpa (kgf/cm², psi) 9.81 ~ 500.14 (0.1 ~ 5.1,1.42 ~ 72.54) Current value(mA ...

Thermostat: Troubleshooting
Symptoms Possible Causes Remedy Coolant leakage • From the thermostat gasket Check the mounting bo ...

Adjustment
ETC module learning procedure When installing new ETC module or re-installing it, ETC module learning procedure must be performed. 1. Hold the ignition key o ...

Copyright © www.kirmanual.com 2014-2024