Kia Rio: Installation - BCM (Body Control Module) - Body Electrical System - Kia Rio UB 2012-2021 Service ManualKia Rio: Installation

1.
Install the BCM.
2.
Install the crash pad lower panel.
Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to the BD group - "Crash pad") ...

Seat Electrical
...

See also:

Description
Knocking is a phenomenon characterized by undesirable vibration and noise and can cause engine damage. Knock Sensor (KS) is installed on the cylinder block and senses engine knocking. Whe ...

Transaxle Control Module (TCM) Inspection
TCM Problem Inspection Procedure 1. TEST TCM GROUND CIRCUIT: Measure resistance between TCM and chassis ground using the backside of TCM harness connector as TCM side c ...

Blower Resistor (MANUAL) Inspection
1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replac ...

Copyright © www.kirmanual.com 2014-2021