Replacing an on/off solenoid valve (SS-A, SS-B) does not require
additional hydraulic pressure adjustment; however, the hydraulic pressure
will need to be adjusted after replacing the VFS solenoid valve. If
replacing the VFS solenoid valve; also replace the valve body assembly.
(Refer to "Valve Body" in this group)
|
Rear Seat Replacement
Rear Seat Assembly Replacement
1.
After loosening the mounting bolt, then remove the rear seat cushion
(A).
Tightening torque :
...
Front Impact Sensor (FIS) Description
The front impact sensor (FIS) is installed in the front side member. They
are remote sensors that detect acceleration due to a collision at its mounting
location. The primary purpose of the F ...
Rain Sensor Installation
•
In case of the windshield with reflection layer which
reflects the infrared rays in se ...