1. |
These dimensions indicate the actual linear distance between measurement
points, and are used as the reference dimensions when a tracking gauge
is used for measurement.
|
2. |
First adjust both probes to the same length (A=A') before measurement.
|
On-vehicle Inspection
Inspect ignition coil assembly and
Perform spark test
1.
Check for DTCs.
...
Evaporator Temperature Sensor Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the evaporator temperature sensor connector.
3.
Measure resistan ...
SRS Control Module (SRSCM) Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three
minutes before beginning ...