Kia Rio: Oil Pump Unit (OPU) Removal - ISG (Idle Stop & Go) System - Engine Control / Fuel System - Kia Rio UB 2012-2026 Service ManualKia Rio: Oil Pump Unit (OPU) Removal

1.
Remove the negative (-) battery terminal.
2.
Remove the crash pad lower panel. (Refer to “Crash pad” in BD group.)
3.
Remove the oil pump unit connector to the left side of the brake pedal.
4.
Remove the oil pump unit (A) after removing the nuts (3ea).


Oil Pump Unit (OPU) Circuit diagram
...

Oil Pump Unit (OPU) Installation
1. Installation is the reverse of removal. ...

See also:

Front Fog Lamps Removal
1. Disconnect the negative (-) battery terminal. 2. Disconnect the fog lamp connector (A). 3. Remove t ...

Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Specifications
Direct control VFS[35R/C] ▷ Control type : Normal low type Control Pressure kpa (kgf/cm², psi) 500.14 ~ 9.81 (5.1 ~ 0.1,72.54 ~ 1.42) Current value(mA ...

Component Location
1. Sunroof 2. Sunroof switch 3. Sunroof motor & controller ...

Copyright www.kirmanual.com 2014-2026