Kia Rio: Rear Shock Absorber Inspection - Rear Suspension System - Suspension System - Kia Rio UB 2012-2019 Service ManualKia Rio: Rear Shock Absorber Inspection

1.
Check the components for damage or deformation.
2.
Compress and extend the piston and check that there is no abnormal resistance or unusual sound during operation.
Rear Shock Absorber Replacement
1. Remove the rear wheel & tire. Tightening torque : 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) ...

Rear Coil Spring Components
1. Spring upper pad 2. Spring 3. Spring lower pad ...

See also:

Replacement
The injector combustion seal should be replaced new one to prevent leakage after removing the injector. 1. Remove the combustion seal (A) with a wire cutter. ...

Description
Engine Coolant Temperature Sensor (ECTS) is located in the engine coolant passage of the cylinder head for detecting the engine coolant temperature. The ECTS uses a thermistor that changes re ...

Oil Pump Unit (OPU) Inspection
OPU Problem Inspection Procedure 1. TEST OPU GROUND CIRCUIT: Measure resistance between OPU and chassis ground using the backside of OPU harness connector ...

Copyright © www.kirmanual.com 2014-2019