Kia Rio: Removal
| 1. |
Disconnect the battery negative cable from the battery and then
wait for at least 30 seconds.
|
| 2. |
Turn the steering wheel so that the front wheels can face straight
ahead.
|
| 3. |
(Refer to “Air bag module / DAB” in RT group)
Remove the airbag module.
|
| 4. |
Disconnect the lock nut (A) & connector (B) and then remove the
steering wheel by using special service tools. (09561-11001)
|
| 5. |
Installation is the reverse of the removal.
|
Component
1. Remote control assembly
2. Airbag module
3. Wiring
4. Heated steering control unit
5. Steering wheel body
6. Lower cover
...
Disaseembly
1.
Loosen the screw(6ea) and remove the lower cover (A) from the
steering wheel body.
2.
Disconnect the heated steering wheel unit ...
See also:
SS-A Solenoid Valve(ON/OFF) Specifications
ON/OFF Solenoid Valve(SS-A, SS-B)
▷ Control type : Normal low type
Control pressure kpa (kgf/cm², psi)
490.33(5.0, 71.12)
Internal resistance(&# ...
Transaxle Control Module (TCM) Installation
1.
Installation is reverse of removal.
In the case of the vehicle equipp ...
Heater Unit Components
1. Shower Duct (Left)
2. Heater Pipe Cover
3. Mode Control Actuator
4. Mode Control Actuator Bracket
5. Defog mode lever (FATC)
6. Mode Control Main Lever (MANUAL)
7. Vent ...
Copyright © www.kirmanual.com 2014-2019