Kia Rio: Inspection

Lighting Switch Inspection

With the multifunction switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the multifunction switch.

Lighting switch (Auto Light)

Lighting switch

HS : Head lamp switch(Short inside)

Dimmer And Passing Switch

Turn Signal Switch

Front Fog Lamp Switch

Wiper And Washer Switch Inspection

With the multifunction switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the multi-function switch.

Wiper Switch (Intermittent)

Washer Switch

Rear wiper switch

Rear washer switch

Component(2)

...

Removal

Wiper and Washer Switch 1. Disconnect the negative (-) battery terminal. 2. Remove the steering wheel. (Refer to the ST group - &qu ...

See also:

Blower Unit Replacement
1. Remove the heater & blower unit. (Refer to HA group - "Heater Unit") 2. Separate the blower unit from the heater unit a ...

Compressor Installation
1. Make sure of the length of compressor mounting bolts, and then tighten it with the specified tightening order. Tightening torque : ...

Evaporator Temperature Sensor Replacement
1. Disconnect the negative (-) battery terminal. 2. Disconnect the evaporator temperature sensor connector (A). 3. ...