Kia Rio: AVN Head Unit Removal
|
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the crash pad center fascia panel (A).
(Refer to the BD group - "Crash pad")
|
| 3. |
Disconnect the center fascia panel connectors (A).
|
| 4. |
Remove the AVN head unit (A) after loosening the mounting screws.
|
| 5. |
Remove the AVN head unit connectors and cables.
|
| 1. |
Remove the rear roof trim.
(Refer to the BD group - "Roof trim")
|
| 2. |
Disconnect the antenna cable and the connector (A).
|
| 3. |
Remove the roof antenna after removing a nut (A).
|
AVN Head Unit Components
AVN Head Unit InstallationThermostat: Components
1. Water inlet fitting
2. Thermostat
3. Heater pipe
4. Water temp control assembly
5. Water temperature sensor
6. Gasket
...
Heater Unit Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Recover the refrigerant with a recovery/recycling/charging station.
3.
...
Engine overheat
If your temperature gauge indicates overheating, you will experience a loss of
power, or hear loud pinging or knocking, the engine is probably too hot. If this
happens, you should:
1.Pull off the ...