Kia Rio: Front Washer Motor Removal - Windshield Wiper/Washer - Body Electrical System - Kia Rio UB 2012-2026 Service ManualKia Rio: Front Washer Motor Removal


     
-
When servicing the washer pump, be careful not to damage the washer pump seal.
-
Do not operate the washer pump before filling the washer reservoir.
Failure to do so could result in premature pump failure.
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front wheel guard (RH).
(Refer to the BD group - "Front wheel guard")
3.
Remove the washer hose and disconnect the washer motor connector (A).


4.
Remove the washer reservoir (A) after removing 2 bolts.


Front Washer Motor Inspection
Front Washer Motor 1. With the washer motor connected to the reservoir tank, fill the reservoir tank with water. &nb ...

Front Washer Motor Installation
1. Install the washer reservoir.    Before installing the pump motor, check ...

See also:

Seat Belt Buckle Switch (BS) Removal
1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work. 2. Remove the front seat assembly. ...

Rain Sensor Inspection
Rain Sensing Wiper 1. In IGN2 ON state, if auto switch input (LIN communication) is ON then both wiper low relay and wiper high relay outputs are controlled by the ...

Foot Actuator (With Auto Defogging System) Replacement
1. Disconnect the negative (-) battery terminal. 2. Remove the glove box housing. (Refer to BD group - “Crash pad”) ...

Copyright © www.kirmanual.com 2014-2026