Kia Rio: Rear Washer Motor Inspection
| 1. |
With the washer motor connected to the reservoir tank, fill the
reservoir tank with water.
|
| 2. |
Remove the front bumper cover. (Refer to the Body group- Front
bumper)
|
| 3. |
Connect positive (+) and negative (-) battery cables to terminals
3 and 2 respectively to see that the washer motor runs and water is
pumped.
|
| 4. |
Check that the motor operates normally.
Replace the motor if it operates abnormally.
1. Front washer (+)
2. Ground
3. Rear washer (-)
|
Rear Washer Switch Inspection
1.
With the rear wiper & washer switch in each position, make sure
that continuity exists between the terminals below. If continuity is
not as specified, replace t ...
See also:
Installation
Installation is in the reverse order of removal.
Perform the following :
•
Adjust a shift cable.
•
Refill engine with engine oil.
...
Circuit Diagram
(M/T)
(A/T)
...
Troubleshooting
Ignition System
Symptom
Suspect Area
Remedy
Engine will not start or is hard to
start (Cranks OK)
Ignition lock switch
Inspect igni ...
Categories
- Kia Rio Manuals Home
- Kia Rio YB 2017-2026 Owners Manual
- Kia Rio YB 2017-2026 Service Manual
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright www.kirmanual.com 2014-2026