Kia Rio: Ignition Switch Assembly Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the steering column upper and lower shrouds.
(Refer to the ST group - "Steering column")
|
| 3. |
Disconnect the ignition switch connector (B) and the key switch
connector (A) from under the steering column.
|
| 4. |
If it is necessary to remove the key lock cylinder (A), remove
the key lock cylinder after pushing lock pin with key ACC.
|
Ignition Switch Assembly Inspection
1.
Disconnect the ignition switch connector (B) and key switch connector
(A) from under the steering column.
2.
Check for continui ...
Ignition Switch Assembly Installation
1.
Install the key lock cylinder.
When assembling, the key must be insert ...
See also:
Rain Sensor Inspection
Rain Sensing Wiper
1.
In IGN2 ON state, if auto switch input (LIN communication) is
ON then both wiper low relay and wiper high relay outputs are controlled
by the ...
Steering Angle Sensor (MDPS Only) Description
The Steering Angle Sensor (SAS) is installed in MDPS (Motor Driven Power
Steering) and it sends messages to HECU through CAN communication line.
The SAS is used to determine turning directio ...
Receiver-Drier Replacement
1.
Remove the condenser.
2.
Remove the cap (B) on the bottom of the condenser with L wrench
(A).
Tightening torq ...
Categories
- Kia Rio Manuals Home
- Kia Rio YB 2017-2026 Owners Manual
- Kia Rio YB 2017-2026 Service Manual
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright www.kirmanual.com 2014-2026