1. |
Turn the ignition switch OFF.
|
2. |
Disconnect the evaporator temperature sensor connector.
|
3. |
Measure resistance between terminal “+” and “-” of evaporator
temperature sensor.
|
4. |
Connect the evaporator temperature sensor connector.
|
5. |
Run the engine and turn the A/C switch ON, then measure the voltage
between the terminals of harness connector.
Specification
|
Installation
1.
Install the BCM.
2.
Install the crash pad lower panel.
...
Instrument Cluster Circuit Diagram
[Standard]
[Supervision]
...
Antenna Removal
1.
Remove the rear roof trim.
(Refer to the Body group - Roof trim).
2.
Disconnect the antenna cable and the connector (A).
...