Kia Rio: Heater Unit Components
| 1. Shower Duct (Left) 2. Heater Pipe Cover 3. Mode Control Actuator 4. Mode Control Actuator Bracket 5. Defog mode lever (FATC) 6. Mode Control Main Lever (MANUAL) 7. Vent Sub lever 8. Vent Door Lever |
9. Foot Sub Lever 10. Heat Case (Left) 11. Heater Core Assembly 12. Aspirator Hose 13.Temperature Control Actuator 14. Temperature Control Actuator Lever 15. Temperature Door Lever |
| 1. NVH Pad 2. Defog Seal 3. Vent Seal 4. Vent/Defog Door 5. Foot Door 6. Temperature Door 7. Evaporator Temperature Sensor Hole Cover 8. Evaporator Temperature Sensor 9. Heater Lower Case 10. Drain Hose |
11. Heater Case (Right) 12. Blower Resistor (MANUAL) 13. Power Mosfet (FATC) 14. Foot Actuator (With auto defogging system) 15. Cool Box Hose 16. Shower Duct (Left) 17. Flange Seal 18. Evaporator Flange Clip 19. Evaporator Core Cover 20. Evaporator Core |
Heater Unit Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Recover the refrigerant with a recovery/recycling/charging station.
3.
...
See also:
Immobilizer Control Unit Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to the BD group - "Crash pad")
...
Description
Knocking is a phenomenon characterized by undesirable vibration and noise
and can cause engine damage. Knock Sensor (KS) is installed on the cylinder
block and senses engine knocking.
Whe ...
Cluster Ionizer (FATC only) Inspection
1.
Press the MODE switch more then 4 times within 2 seconds while
pressing the OFF switch.
Display
Fail description
00 ...
Categories
- Kia Rio Manuals Home
- Kia Rio YB 2017-2025 Owners Manual
- Kia Rio YB 2017-2025 Service Manual
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright www.kirmanual.com 2014-2025