Kia Rio Manuals

Kia Rio: Intake Actuator Inspection - Blower - Heating,Ventilation, Air Conditioning - Kia Rio UB 2012-2026 Service ManualKia Rio: Intake Actuator Inspection

1.
Turn the ignition switch OFF.
2.
Disconnect the intake actuator connector.
3.
Verify that the intake actuator operates to the fresh position when connecting 12V to terminal 4 and grounding terminal 3.
Verify that the intake actuator operates to the recirculation position when connecting in the reverse.


1. -                 
2. –                  
3. Recirculation
4. Fresh              
5. Sensor Ground
6. Feedback Signal
7. Sensor (+ 5V)

4.
Connect the intake actuator connector.
5.
Turn the ignition switch ON.
6.
Check the voltage between terminal 6 and 5.
Specification
Door position
 Voltage (V)
Error detecting
Fresh
 0.5
 Low voltage : 0.1V or less
Recirculation
 4.5
 High voltage : 4.9V or more

7.
If the intake actuator is not operated well, substitute with a known-good intake actuator and check for proper operation.
8.
Replace the intake actuator if it is proved that there is a problem with it.
Intake Actuator Description
The intake actuator is located at the blower unit. It regulates the intake door by signal from control unit. Pressing the intake selection switch will shift between recirculation and fresh ai ...

Intake Actuator Replacement
1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad. (Refer to BD group - "Crash Pad") ...

See also:

Installation
1. Installation is the reverse of removal.    • ...

Interior light
Do not use the interior lights for extended periods when the engine is not running. It may cause battery discharge. WARNING - Interior light Do not use the interior lights when driving in the dark. ...

Installation
1. Install the back view camera. 2. Install the tailgate trim. ...

Categories

Copyright www.kirmanual.com 2014-2026