Kia Rio: Reassembly
| •
|
Thoroughly clean all parts to be assembled.
|
| •
|
Before installing the parts, apply fresh engine oil to
all sliding and rotating surface.
|
| •
|
Replace oil seals with new ones.
|
|
|
1. |
Install the valves.
|
(1) |
Install the spring seats.
|
|
(2) |
Using the SST (09222 - 2B100), push in a new oil seal.
|
Do not reuse old valve stem oil seals.
Incorrect installation of the seal could result
in oil leakage past the valve guides.
|
|
Intake valve stem seals are different from exhaust
ones in type. Do not reassembly ones in the other's
places.
|
|
|
(3) |
Install the valve, valve spring and spring retainer, after
applying engine oil at the end of each valve.
|
When installing valve springs, the enamel coated
side should face the valve spring retainer.
|
|
|
|
2. |
Using the SST(09222 - 3K000, 09222 - 3K100), compress the spring
and install the retainer locks.
After installing the valves, ensure that the retainer locks are
correctly in place before releasing the valve spring compressor.
|
When installing the SST, use the torque, 1.2kgf.m or less.
|
|
|
3. |
Lightly tap the end of each valve stem two or three times with
the wooden handle of a hammer to ensure proper seating of the valve
and retainer lock.
|
|
4. |
Install the MLA(Mechanical lash adjuster)s.
Check that the MLA (A) rotates smoothly by hand.
|
All the MLAs should be installed in its original position.
|
|
Cylinder Head
1.
Inspect for flatness.
Using a precision straight edge and feeler gauge, measure the
surface the contacting the cylinder block and the manifolds ...
•
Thoroughly clean all parts to be assembled.
•
...
Inspection
Installation