Kia Rio: Inspection - Cooling System - Engine Mechanical System - Kia Rio UB 2012-2026 Service ManualKia Rio: Inspection

1.
Immerse the thermostat in water and gradually heat the water.


2.
Check the valve opening temperature.

Valve opening temperature : 82±1.5°C (179.6±2.7°F)
Full opening temperature : 95°C (203°F)

If the valve opening temperature is not as specified, replace the thermostat.
3.
Check the valve lift.

Valve lift : 8mm(0.3in) or more at 95°C (203°F)

If the valve lift is not as specified, replace the thermostat.
Thermostat: Removal
   Disassembly of the thermostat would have an adverse effect, causing a lowering of cooling efficiency. ...

Thermostat: Installation
1. Place the thermostat in the block. Install the thermostat (B) with the jiggle valve upward. 2. Install the water inlet fitting (A). ...

See also:

Components Location
1. AVN (A/V & Navigation head unit) 2. Midrange speaker 3. Roof antenna (GPS Radio) 4. Front door speaker 5. Rear door speaker 6. Antenna feeder cable 7. Feeder ca ...

Component Location
1. Sunroof 2. Sunroof switch 3. Sunroof motor & controller ...

Driver Airbag (DAB) Module and Clock Spring Inspection
Driver Airbag (DAB) If any improper parts are found during the following inspection, replace the airbag module with a new one.    ...

Copyright © www.kirmanual.com 2014-2026