Kia Rio: Specification - Engine Electrical System - Kia Rio UB 2012-2024 Service ManualKia Rio: Specification

Ignition System
Ignition Coil
Item
Specification
Primary Coil Resistance (Ω)
0.75 ± 15% [20°C (68°F)]
Secondary Coil Resistance (kΩ)
5.9 ± 15% [20°C (68°F)]

Spark plug
Item
Specification
Type
SILZKR6B10E
Gap
0.9 ~ 1.0 mm (0.0354 ~ 0.0394 in.)

Condenser
Item
Specification
Capacitance (uF)
0.47 [1KHz]
Insulation resistance (mΩ)
1,000 [DC 500 V/1 Min]

Charging System
Alternator [AMS type (NON-OAD)]
Item
Specification
Rated voltage
13.5V, 90A
Speed in use
1,000 ~ 18,000 rpm
Voltage regulator
IC Regulator built-in type
Regulator Setting Voltage
External mode
Refer to below graph
Internal mode
14.55 ± 0.3V
Temperature Gradient
External mode
0 ± 3 mV / °C 
Internal mode
-3.5 ± 2mV / °C


※ Regulator Setting Voltage (External mode)
Alternator [ISG type (NON-DAD) / AMS type (OAD)]
Item
Specification
Rated voltage
13.5V, 110A
Speed in use
1,000 ~ 18,000 rpm
Voltage regulator
IC Regulator built-in type
Regulator Setting Voltage
External mode
Refer to below graph
Internal mode
14.55 ± 0.3V
Temperature Gradient
External mode
0 ± 3 mV / °C
Internal mode
-3.5 ± 2mV / °C


※ Regulator Setting Voltage (External mode)
Battery [Non-ISG type]
Item
Specification
Model type
CMF45L-BCI
Capacity [20HR/5HR] (AH)
45/36
Cold Cranking Amperage (A)
410 (SAE) / 330 (EN)
Reserve Capacity (Min)
80

AGM Battery [ISG type]
Item
Specification
Model type
AGM 70L-DIN
Capacity [20HR/5HR] (AH)
70/56
Cold Cranking Amperage (A)
760 (SAE) / 610 (EN)
Reserve capacity (Min)
120


     
Model type description


Cold Cranking Ampere (CCA): Cold Cranking Amps is a rating used in the battery industry to define a battery's ability to start an engine in cold temperatures.
-
The rating is the number of amps a new, fully charged battery can deliver at -18 °C(-0.4 °F) for 30 seconds, while maintaining a voltage of at least 7.2 volts for a 12 volt battery.
-
The higher the CCA rating, the greater the starting power of the battery.
RESERVE CAPACITY (RC) : Reserve Capacity is a battery industry rating, defining a battery's ability to power a vehicle with an inoperative alternator or fan belt.
-
The rating is the number of minutes a battery at 26.7 °C(80 °F) can be discharged at 25 amps and maintain a voltage of 10.5 volts for a 12 volt battery.
-
The higher the reserve rating, the longer your vehicle can operate should your alternator or fan belt fail.
Starting System
Starter [Non-ISG type]
Item
Specification
Rated voltage
12 V, 0.9 kW
The number of pinion teeth
10
Performance
[No-load, 11.5 V]
Ampere
Max. 60 A
Speed
Min. 5,500 rpm

Starter [ISG type]
Item
Specification
Rated voltage
12 V, 1.3 kW
The number of pinion teeth
11
Performance
[No-load, 12 V]
Ampere
Max. 95 A
Speed
Min. 3400 rpm

Engine Electrical System
...

Tightening Torques
Item N.m kgf.m lb-ft Ignition coil installation bolt 9.8 ~ 11.8 1.0 ~ 1.2 7.2 ~ 8.7 Spark plug installation 14.7 ~ ...

See also:

General Troubleshooting Information
Before Troubleshooting 1. Check applicable fuses in the appropriate fuse/relay box. 2. Check the battery for damage, state of charge, and cl ...

Transaxle Oil Temperature Sensor Description
Transaxle oil temperature sensor monitors the automatic transaxle fluid's temperature and conveys the readings to TCM. It is an NTC (Negative Thermal Coefficient) sensor whose resistance ...

Condenser Replacement
1. Recover the refrigerant with a recovery/recycling/charging station. 2. Disconnect the negative (-) battery terminal. 3. ...

Copyright © www.kirmanual.com 2014-2024