Kia Rio: Description

Ignition timing is controlled by the electronic control ignition timing system.

The standard reference ignition timing data for the engine operating conditions are pre-pro grammed in the memory of the ECM (Engine Control Module).

The engine operating conditions (speed, load, warm-up condition, etc.) are detected by the various sensors. Based on these sensor signals and the ignition timing data, signals to interrupt the primary current are sent to the ECM.

The ignition coil is activated, and timing is controlled.

Ignition System

...

On-vehicle Inspection

Inspect ignition coil assembly and Perform spark test 1. Check for DTCs.    ...

See also:

Side Airbag (SAB) Module Removal
   The side airbag cannot be disassembled from the seat back assembly, so replace the seat back assembly when replacing the ...

Inspection
1. Turn the ignition switch OFF. 2. Disconnect the PCSV connector. 3. Measure resistance between the PCSV termi ...

Seat Heater Switch Schematic Diagram
...