Kia Rio Manuals

Kia Rio: Spark Plug: Inspection - Ignition System - Engine Electrical System - Kia Rio UB 2012-2026 Service ManualKia Rio: Spark Plug: Inspection

[On vehicle inspection]
1.
Accelerate the engine to about 3,000 rpm 3 times or more.
2.
Remove the spark plug.
3.
Check the spark plug visually.
If the electrode is dry, the spark plug is normal.
If the electrode is wet, check the damage and electrode gap as below.
[Component Inspection]
1.
Check the spark plug for any damage on its thread and insulator.
If there is damage, replace the spark plug.
2.
Check the electrode. Measure the insulation resistance with an ohmmeter.
If the resistance is less than the specified value, adjust the electrode gap.
Specification: 10 MΩ or more


3.
Check the spark plug electrode gap.
If the gap is greater than the maximum, replace the spark plug.
Specification: 0.9 ~ 1.0 mm (0.0354 ~ 0.0394 in.)

     
•
If adjusting the gap of a new spark plug, bend only the base of the ground electrode. Do not touch the tip.
Never attempt to adjust the gap on a used plug.


Spark Plug: Specification
Item Specification Type SILZKR6B10E Gap 0.9 ~ 1.0 mm (0.0354 ~ 0.0394 in.) ...

Spark Plug: Cleaning
The combustion temporarily becomes unstable, due to the aged fuel and the carbon deposits accumulated on the spark plug(s) after long-term storage. [1st Method] 1. ...

See also:

Climate control air filter
The climate control air filter installed behind the glove box filters the dust or other pollutants that come into the vehicle from the outside through the heating and air conditioning system. If ...

Rear Wiper Motor Inspection
Rear Wiper Motor 1. Remove the 4P connector from the rear wiper motor. 2. Connect battery positive (+) and negative (-) cables to terminals ...

ISG OFF Switch: Inspection
1. Remove the crash pad side switch assembly (A) from the switch panel on the crach pad of the driver's side. 2. Remove the ISG ...

Categories

Copyright www.kirmanual.com 2014-2026