Kia Rio: Removal
| 1. |
Disconnect the battery negative terminal.
|
| 2. |
Disconnect the air compressor connector (A) and the alternator
connector (B), and remove the cable from alternator "B" terminal (C).
|
| 3. |
Loosen the mounting bolts, and then turn the adjusting bolt (A)
clockwise to loosen tension.
|
| 4. |
Remove the drive belt (A).
|
| 5. |
Remove the alternator (A) after remove the mounting bolts.
|
Circuit Diagram
...
Installation
1.
Install in the reverse order of removal.
2.
Adjust the alternator belt tension after installation.
(Refer to Engine charging Sy ...
See also:
Anchor Pretensioner (APT) Installation
1.
Remove ignition key from the vehicle.
2.
Disconnect the negative (-) cable from battery and wait for at
least thirty seconds.
...
Mode Control Actuator Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad.
(Refer to BD group - "Crash Pad")
...
Hazard Lamp Switch Removal
1.
Disconnect the negative (-) battery terminal.
2.
Using a screwdriver or trim remover, remove the hazard lamp switch
(A).
...
Categories
- Kia Rio Manuals Home
- Kia Rio YB 2017-2026 Owners Manual
- Kia Rio YB 2017-2026 Service Manual
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright www.kirmanual.com 2014-2026