Kia Rio: Starter: Disassembly
| 1. |
Disconnect the M-terminal (A) on the magnet switchassembly.
|
| 2. |
After loosening the 2 screws (A), detach the magnetswitch assembly
(B).
|
| 3. |
Loosen the brush holder mounting screw (A) and the trough bolts
(B).
|
| 4. |
Remove the rear bracket (A) and brush holderassembly (B).
|
| 5. |
Remove the yoke (A).
|
| 6. |
Remove the packing (A), lever plate (B), lever (C), armature (D).
|
| 7. |
Press the stopper (A) using a socket (B).
|
| 8. |
After removing the stop ring (A) using stopper pliers (B).
|
| 9. |
Remove the stop ring (B), stopper (A), overrunningclutch (C) and
armature (D).
|
Starter: Installation
1.
Install in the reverse order of removal.
Starter installation bolt:
49.0 ~ 63.7 N.m (5.0 ~ 6.5 kgf.m, 36.2 ~ 47.0 lb-ft)
...
Starter: Reassembly
1.
Reassemble in the reverse order of disassembly.
...
See also:
Emission control system
The emission control system of your vehicle is covered by a written limited warranty.
Please see the warranty information contained in the Warranty & Maintenance booklet
in your vehicle.
Your ...
Crash Pad Components
(1)
1 . Main crash pad assembly
2 . Crash pad side cover [LH]
3 . Crash pad side cover [RH]
4 . Fuse box cover
5 . Crash pad lower panel
6 . Knee bolster panel
7 . St ...
SRS Control Module (SRSCM) Variant coding
After replacing the SRSCM with a new unit, the “Variant Coding” procedure
must be performed.
1.
...
Categories
- Kia Rio Manuals Home
- Kia Rio YB 2017-2026 Owners Manual
- Kia Rio YB 2017-2026 Service Manual
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright www.kirmanual.com 2014-2026