Kia Rio: Inspection| 1. |
After disconnecting the vapor hose from the PCV valve, remove
the PCV valve.
|
| 2. |
Reconnect the PCV valve to the vapor hose.
|
| 3. |
Run the engine at idle, then put a finger over the open end of
the PCV valve and make sure that intake manifold vacuum can be felt.
|
| 4. |
If the vacuum is not felt inspect PCV operation, if operating
correctly clean or replace the vapor hose.
|
Trouble Symptom Charts
Trouble Symptom 1
Trouble Symptom 2
Trouble symptom
Probable cause
Remedy
The set vehicle speed varies greatly upward or downward
"Surgin ...
35R Clutch Control Solenoid Valve(35R/C_VFS) Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require
additional hydraulic pressure adjustment; however, the ...
Defroster
CAUTION - Conductors
To prevent damage to the conductors bonded to the inside surface of the rear
window, never use sharp instruments or window cleaners containing abrasives to clean
the window. ...