Kia Rio: Installation
| •
|
Install the component with the specified torques.
|
| •
|
Note that internal damage may occur when the component
is dropped. If the component has been dropped, inspect before
installing.
|
|
|
1. |
Installation is reverse of removal.
Electronic throttle body Installation
bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
|
|
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Remove the resonator and the air intake hose (Refer to ...
ETC module learning procedure
When installing new ETC module or re-installing it, ETC module learning
procedure must be performed.
1.
Hold the ignition key o ...
See also:
Cluster Ionizer (FATC only) Inspection
1.
Press the MODE switch more then 4 times within 2 seconds while
pressing the OFF switch.
Display
Fail description
00 ...
Dynamic Damper Components
1. BJ assembly
2. Circlip
3. BJ boot band
4. BJ boot
5. Dynamic damper band
6. Dynamic damper
7. Shaft
8. TJ boot band
9. TJ boot
10. Spider assembly
1 ...
Turn Signal Lamp (Door mirror) Removal
Door Mirror Turn Signal Lamp
1.
Using a screwdriver or remover, remove the mirror (A) from th
mirror holder.
Becareful not to damage to the clip.
...
Removal
Adjustment