Kia Rio: Adjustment
| ETC module learning procedure |
When installing new ETC module or re-installing it, ETC module learning
procedure must be performed.
| 1. |
Hold the ignition key or the start button at the IG ON position
during 5 seconds.
|
| 2. |
Turn ignition swich OFF and then start the engine.
|
DTC codes (P0638, P2110) might be displayed if ETC module learning
procedure does not performed after replacing ETC module.
|
Installation
•
Install the component with the specified torques.
•
...
See also:
Brake Switch Inspection
1.
Connect a circuit tester to the connector of stop lamp switch,
and check whether or not there is continuity when the plunger of the
stop lamp switch is pushed in an ...
SS-A Solenoid Valve(ON/OFF) Description
SS-A solenoid valve is attached to the valve body and is an on/off solenoid
valve that is used to change gears. SS-A Solenoid valve(ON/OFF) is installed
at valve body.
...
Temperature Control Actuator Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the temperature control actuator connector.
3.
Verify that the t ...
Categories
- Kia Rio Manuals Home
- Kia Rio YB 2017-2026 Owners Manual
- Kia Rio YB 2017-2026 Service Manual
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright www.kirmanual.com 2014-2026