Kia Rio Manuals

Kia Rio: Installation - Crankshaft Position Sensor (CKPS) - Engine Control System - Engine Control / Fuel System - Kia Rio UB 2012-2026 Service ManualKia Rio: Installation


     
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.

     
•
Apply the engine coolant to the O-ring.

     
•
Insert the sensor in the installation hole and be careful not to damage.
1.
Installation is reverse of removal.
Engine Coolant Temperature Sensor installation :
29.4 ~ 39.2 N.m (3.0 ~ 4.0 kgf.m, 21.7 ~ 28.9 lb-ft)
Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the engine coolant temperature sensor connecto ...

Crankshaft Position Sensor (CKPS)
...

See also:

Foot Actuator (With Auto Defogging System) Replacement
1. Disconnect the negative (-) battery terminal. 2. Remove the glove box housing. (Refer to BD group - “Crash pad”) ...

Oil Pressure Switch: Inspection
1. Check the continuity between the terminal and the body with an ohmmeter. If there is no continuity, replace the oil pressure switch. 2. ...

Yaw-rate and G Sensor Description
When the vehicle is turning with respect to a vertical axis the yaw rate sensor detects the yaw rate electroniclly by the vibration change of plate fork inside the yaw rate sensor. If yaw ...

Categories

Copyright www.kirmanual.com 2014-2026