Kia Rio: Installation
| •
|
Install the component with the specified torques.
|
| •
|
Note that internal damage may occur when the component
is dropped. If the component has been dropped, inspect before
installing.
|
|
| •
|
Apply the engine oil to the O-ring.
|
|
| •
|
Insert the sensor in the installation hole and be careful
not to damage.
|
|
|
1. |
Installation is reverse of removal.
Crankshaft position sensor installation
bolt:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
|
|
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the crankshaft position sensor connector (A) ...
See also:
Oil Pump Components
1. Oil pump cover
2. Oil pump housing
3. Driven gear
4. Drive gear
5. Oil seal
6. Bushing-housing
7. Reaction shaft
8. Bushing-reaction shaft
9. Sleeve
10 ...
Front Seat Belt Replacement
Front Seat Belt Replacement
•
When installing the belt, make sure not to damaged the
...
Windshield Wiper-Washer Switch Removal
Wiper and Washer Switch
1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering wheel.
(Refer to the ST group - &qu ...
Removal
