Kia Rio: Removal
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Remove the intake manifold (Refer to “Intake And Exhaust System”
in EM group).
|
| 3. |
Disconnect the injector connector (A).
|
| 4. |
Remove the installation bolt (B), and then remove the sensor from
the cylinder block.
|
Circuit Diagram
(M/T)
(A/T)
...
Installation
•
Install the component with the specified torques.
•
...
See also:
Front Impact Sensor (FIS) Description
The front impact sensor (FIS) is installed in the front side member. They
are remote sensors that detect acceleration due to a collision at its mounting
location. The primary purpose of the F ...
Component(1)
※ Installation order : A → B → C → D → E
1. Steering column shaft
2. Lighting switch
3. Wiper and washer switch
4. Screw
5. Steering angle ...
Radiator: Inspection
Radiator Cap Testing
1.
Remove the radiator cap, wet its seal with engine coolant, then
install it to pressure tester.
2.
Apply ...
Categories
- Kia Rio Manuals Home
- Kia Rio YB 2017-2026 Owners Manual
- Kia Rio YB 2017-2026 Service Manual
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright www.kirmanual.com 2014-2026