Kia Rio: Circuit Diagram

Signal Waveform

...

Inspection

1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the RPS at idle and various engine speed. ...

See also:

Alternator: Removal and installation
1. Disconnect the battery negative terminal first, then the positive terminal. Tightening torque (+) terminal : 7 ...

Starter: Inspection
Starter Solenoid Inspection 1. Disconnect the lead wire from the M-terminal of solenoid switch. 2. Connect the battery as shown. If ...

Description
Back view camera will activate when the backup light is ON with the ignition switch ON and the shift lever in the R position. This system is a supplemental system that shows behind the vehic ...