Kia Rio Manuals

Kia Rio: Removal - Rail Pressure Sensor (RPS) - Engine Control System - Engine Control / Fuel System - Kia Rio UB 2012-2026 Service ManualKia Rio: Removal

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Release the residual pressure in fuel line (Refer to the Fuel Delivery System - Repair Procedures - "Release Residual Pressure in Fuel Line").

     
When removing the fuel pump relay, a Diagnostic Trouble Code (DTC) may occur. Delete the code with the GDS after completion of “Release Residual Pressure in Fuel Line” work.
3.
Remove the intake manifold (Refer to “Intake And Exhaust System” in EM group).
4.
Disconnect the rail pressure sensor connector (A), and then remove the sensor (B) from the delivery pipe.
Inspection
1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the RPS at idle and various engine speed. ...

Installation
   • Install the component with the specified torques. • ...

See also:

Components
...

Troubleshooting
Symptom Suspect area Remedy Engine misfire with abnormal internal lower engine noises. Loose or improperly installed engine flywheel. Repair or replace ...

Ignition Coil: Description
An ignition coil is an induction coil in an engine's ignition system which transforms the battery's low voltage to the high voltage needed to create an electric spark in the spark plu ...

Categories

Copyright www.kirmanual.com 2014-2026