Kia Rio: Removal
In case of removing the high pressure fuel pump, high pressure
fuel pipe, delivery pipe, and injector, there may be injury caused by
leakage of the high pressure fuel. Before repairing the high pressure
system, be sure to release the residual pressure in fuel line as step
2 in below procedure.
|
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Release the residual pressure in fuel line (Refer to the Fuel
Delivery System - Repair Procedures - "Release Residual Pressure in
Fuel Line").
|
| 3. |
Remove the delivery pipe & injector assembly (Refer to "Delivery
Pipe" in this group).
|
| 4. |
Remove the connector (A) and the fixing clip (B), and then separate
the injector from the delivery pipe.
|
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the injector connector.
3.
Measure resistance between the inject ...
Installation
1.
Combustion seal
2.
Rubber washer
3.
Support disc
4.
O-ring
...
See also:
Wiper blades
Blade inspection
Commercial hot waxes applied by automatic car washes have been known to make
the windshield difficult to clean.
Contamination of either the windshield or the wiper blades with f ...
Rear Hub - Carrier Components
[Drum Type]
1. Rear torsion beam assembly
2. Brake assembly
3. Rear wheel hub assembly
4. Rear brake disc
5. Rear brake disc mounting screw
...
Operation and Leakage Check
Check all of the following items:
Component
Procedure
Brake Booster (A)
Check brake operation by applying the brakes during a test drive.
If the brak ...
Categories
- Kia Rio Manuals Home
- Kia Rio YB 2017-2026 Owners Manual
- Kia Rio YB 2017-2026 Service Manual
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright www.kirmanual.com 2014-2026