Kia Rio: Installation
| •
|
Do not reuse the used injector fixing clip.
|
|
| •
|
Install the component with the specified torques.
|
| •
|
Note that internal damage may occur when the component
is dropped. If the component has been dropped, inspect before
installing.
|
|
| •
|
Apply engine oil to the injector O-ring.
|
| •
|
Do not reuse the used injector O-ring.
|
|
| •
|
Do not reuse the used bolt.
|
|
| •
|
When inserting the injector, be careful not to damage
the injector tip.
|
|
| •
|
Do not reuse the support disc.
|
| •
|
Do not reuse the injector rubber washer.
|
| •
|
When replacing the rubber washer, the steal plate (A)
part should be faced the cylinder installation part and the
rubber plate (B) part should be faced the injector body part.
|
|
| •
|
Do not reuse the combustion seal.
|
|
|
1. |
Installation is reverse of removal.
|
In case of removing the high pressure fuel pump, high pressure
fuel pipe, delivery pipe, and injector, there may be inju ...
The injector combustion seal should be replaced new one to prevent leakage
after removing the injector.
1.
Remove the combustion seal (A) with a wire cutter.
...
See also:
Installation
•
Install the component with the specified torques.
•
...
Lubricants
Engine
Lubricants
Quantity
Gasoline 1.6(MT)
BJ
GRB006
80g
TJ
SH06 - VX21
LH:130g, RH:115g
...
Antenna Installation
1.
Install the roof antenna, then connect the cable and the connector.
2.
Install the rear roof trim.
...
Removal
Replacement