Kia Rio: Brake Booster Vacuum Pressure Sensor: Inspection
| 1. |
Check installation status of BBVPS and Vacuum hose or damage of
vacuum hose.
|
| 2. |
Connect GDS to DLC (Data Link Cable).
|
| 3. |
Warm up the engine to normal operating temperature.
|
| 4. |
Monitor "BBVPS" parameter on GDS.
Fig.1) Idle Status
Fig.2) Brake pressure signal
|
AGM Battery: Description
AGM battery is used for especially heavy load on the vehicle network depending
on equipment and requirements. AGM stands for Absorbent Glass Material Battery;
that is absorbent glass fibre fl ...
See also:
Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Specifications
Direct control VFS[35R/C]
▷ Control type : Normal low type
Control Pressure kpa (kgf/cm², psi)
500.14 ~ 9.81 (5.1 ~ 0.1,72.54 ~ 1.42)
Current value(mA ...
Inspection
Rear Brake Disc Thickness Check
1.
Check the brake pads for wear and fade.
2.
Check the brake disc for damage and cracks.
...
Anchor Pretensioner (APT) Installation
1.
Remove ignition key from the vehicle.
2.
Disconnect the negative (-) cable from battery and wait for at
least thirty seconds.
...
Categories
- Kia Rio Manuals Home
- Kia Rio YB 2017-2026 Owners Manual
- Kia Rio YB 2017-2026 Service Manual
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright www.kirmanual.com 2014-2026