Kia Rio: Starter: Removal and Installation
| 1. |
Disconnect the battery negative terminal.
|
| 2. |
Remove the air duct and air cleaner assembly. (Refer to EM group)
|
| 3. |
Disconnect the starter cable (B) from the B terminal on the solenoid
then disconnect the connector (A) from the S terminal.
|
| 4. |
Remove the 2 bolts holding the starter, then remove the starter
(A).
|
| 5. |
Installation is the reverse of removal.
|
Starter: Description
The starting system includes the battery, starter, solenoid switch, inhibitor
switch (A/T), ignition switch, ignition lock switch, connection wires and the
battery cable.
When the ignitio ...
Electric Oil Pump: Description
This transaxle has a standard Mechanical Oil Pump (MOP) linked to the
input shaft to generates oil pressure when input shaft rotates.
But, this transaxle equipped with ISG system also has ...
See also:
Installation
When replacing the ECM, the vehicle equipped with immobilizer
must be performed the procedure as below.
...
Storage compartment
These compartments can be used to store small items.
To avoid possible theft, do not leave valuables in the storage compartment. Always
keep the storage compartment covers closed while driving. Do ...
Input Speed Sensor Signal Waveform
Fig 1) Input/Output speed sensor at low speed
Fig 2) Input/Output speed sensor at high speed ...
Copyright © www.kirmanual.com 2014-2024