Kia Rio: Brake Switch Removal

Brake Switch Inspection

1. Connect a circuit tester to the connector of stop lamp switch, and check whether or not there is continuity when the plunger of the stop lamp switch is pushed in an ...

Brake Switch Installation

1. Install is reverse of removal. ...

See also:

Auto Light Switch Inspection
Operate the auto light switch, then check for continuity between terminals of multi-function switch connector. ...

TPMS Sensor Diagnosis procedure by using diagnostic device
As manual for diagnosis methods by using diagnosis device, the main contents are as follows: 1. Connect self-diagnosis connector(16pins) located in the lower of driv ...

TJ Joint Components
[LH] 1. BJ assembly 2. BJ circlip 3. BJ boot band 4. BJ boot 5. Shaft 6. TJ boot band 7. TJ boot 8. Spider assembly 9. Snap ring 10. TJ c ...