The hazard warning flasher should be used whenever you find it necessary to stop the car in a hazardous location. When you must make such an emergency stop, always pull off the road as far as possible.
The hazard warning lights are turned on by pushing in the hazard switch. Both turn signal lights will blink. The hazard warning lights will operate even though the key is not in the ignition switch.
To turn the hazard warning lights off, push the switch again.
Battery saver function
If necessary, to keep the lights on when the ignition key is removed, perform the following :
1) Open the driver-side door.
2) Turn the parking lights OFF and ON again using the light switch on the steering column.
Component Location
1. Driver power window main switch
2. Passenger power window switch
3. Front window motor
4. Rear window motor
5. Rear window switch
...
Disassembly
1.
Remove the rear cover (A) after removing nuts.
2.
Remove the mounting bolts (A) and the brush holder assembly (B).
...
Cluster Ionizer (FATC only) Description
The cluster ionizer helps to clean up odors in the vehicle or from the
air-conditioner system.
When the ignition switch ON, the inoizer runs a "CLEAN" mode and then
a "ION& ...