Kia Rio Manuals

Kia Rio: Fuel Pump Inspection - Fuel Delivery System - Engine Control / Fuel System - Kia Rio UB 2012-2026 Service ManualKia Rio: Fuel Pump Inspection

[Fuel pump]
1.
Turn ignition switch OFF and disconnect the negative (-)battery cable.
2.
Remove the fuel pump assembly.
3.
Check motor operation by fuel pump connector (A) connecting power(No.2) and ground(No.4)


Pin No.
 discription
1
 Fuel sender signal
2
 Fuel pump (+)
3
 Fuel sender ground
4
 Fuel pump (-)

[Fuel sender]
1.
Using an ohmmeter, measure the resistance between terminals 1 and 3 of sender connector (A) at each float level.


Pin No.
 discription
1
 Fuel sender signal
2
 Fuel pump (+)
3
 Fuel sender ground
4
 Fuel pump (-)

2.
Also check that the resistance changes smoothly when the float is moved from "E" to "F".
Position
 Resistance (Ω)
 Capacity (ℓ)
E
 197 ~ 203
 2.8
 1/2
 64.2 ~ 68.2
 22.3
F
 6 ~ 10
 41.8

Fuel Pump Installation
1. Installation is reverse of removal. Fuel pump plate cover installation bolt : 1.96 ~ 2.94 N.m (0.2 ~ 0.3 kgf.m, 1.44 ~ 2.17 lb- ...

Fuel Filter Replacement
1. Remove the fuel pump (Refer to “Fuel Pump” in this group). 2. Disconnect the electric pump wiring connector (A) and the fuel sender ...

See also:

Hazard warning flasher   lighting
The hazard warning flasher should be used whenever you find it necessary to stop the car in a hazardous location. When you must make such an emergency stop, always pull off the road as far as po ...

Power Door Lock Switch Removal
1. Disconnect the negative(-) battery terminal. 2. Remove the front door trim panel. (Refer to the BD group - "Front door") ...

TPMS Receiver Replacement
   When the receiver first arrives for replacement: 1) It will be in Virgin State. ...

Categories

Copyright www.kirmanual.com 2014-2026