Kia Rio: Delivery Pipe Installation
| •
|
Do not use already used injector fixing clip again.
|
|
|
Do not reuse the support disc.
Do not reuse the injector rubber washer.
Do not reuse the combustion seal.
|
| •
|
Install the component with the specified torques.
|
| •
|
Note that internal damage may occur when the component
is dropped. In this case, use it after inspecting.
|
|
| •
|
Apply engine oil to the injector O-ring.
|
| •
|
Do not use already used injector O-ring again.
|
|
| •
|
Do not use already used bolt again.
|
|
| •
|
When insert the injector, be careful not to damage the
injector tip.
|
|
|
1. |
Installation is reverse of removal.
Delivery pipe installation bolt:
18.6 ~ 23.5 N.m (1.9 ~ 2.4 kgf.m, 13.7 ~ 17.4 lb-ft)
High pressure fuel pipe installation
nut:
26.5 ~ 32.4 N.m (2.7 ~ 3.3 kgf.m, 19.5 ~ 23.9 lb-ft)
|
|
In case of removing the high pressure fuel pump, high pressure
fuel pipe, delivery pipe, and injector, there may be inju ...
In case of removing the high pressure fuel pump, high pressure
fuel pipe, delivery pipe, and injector, there may be inju ...
See also:
Removal
•
Frequent inhalation of brake pad dust, regardless of material
composition, could be ...
Description
Rail Pressure Sensor (RPS) is installed on the delivery pipe and measures
the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor
element) built in the sensor ...
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the MAPS at idle and IG ON.
Spe ...
Delivery Pipe Removal
High Pressure Fuel Pump Removal