Kia Rio: Installation
|
1. |
Installation is the reverse of removal.
|
|
If the oil seal on the transaxle case side is damaged and fluid
is leaking, replace the oil seal with a new unit. When installing the
new oil seal, use the specialized tool (oil seal installer, 09452-26100).
|
|
After replacement or reinstallation procedure of the automatic
transaxle assembly, must perform procedures below.
| •
|
Power steering fluid replacement and air bleeding. (Refer
to "General information" in ST group)
|
| •
|
Adding automatic transaxle fluid. (Refer to "Hydraulic
system (Fluid)" in this group)
|
| •
|
After servicing the automatic transaxle or TCM, clear
the diagnostic trouble codes (DTC) using the GDS tool.
Diagnostic trouble codes (DTC) cannot be cleared by disconnecting
the battery.
|
| •
|
When deleting diagnostic trouble code, use the GDS as
possible.
|
| •
|
When replacing the automatic transaxle, reset the automatic
transaxle's values by using the GDS.
|
| •
|
Perform TCM learning after replacing the transaxle to
prevent slow transaxle response, jerky acceleration and jerky
startup. (Refer to "Automatic transaxle control system (Repair
procedures)" in this group)
|
|
1.
Remove the following items;
A.
Air cleaner assembly (A) and air duct (B).
(Refer to "Intake and Exhaust system" ...
See also:
Seat Belt Buckle Switch (BS) Description
The SRSCM shall monitor the status of the driver and front passenger seat
belt buckle. The SRSCM provides one pin each for the driver and front passenger
seat belt buckle status input. The se ...
Brake Switch Installation
1.
Install is reverse of removal.
...
Delivery Pipe Removal
In case of removing the high pressure fuel pump, high pressure
fuel pipe, delivery pipe, and injector, there may be inju ...
Removal
Hydraulic System