Kia Rio: 26 Brake Control Solenoid Valve(26/B_VFS) Inspection

1.	Turn ignition switch OFF.

2.	Disconnect the solenoid valve connector.

3.	Measure resistance between sensor signal terminal and sensor ground terminal.

4.	Check that the resistance is within the specification.

26 Brake Control Solenoid Valve(26/B_VFS) Circuit Diagram

...

26 Brake Control Solenoid Valve(26/B_VFS) Removal

Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the ...

See also:

Description
Engine Coolant Temperature Sensor (ECTS) is located in the engine coolant passage of the cylinder head for detecting the engine coolant temperature. The ECTS uses a thermistor that changes re ...

Replacement
Rear Brake Pads 1. Loosen the guide rod bolt (B) and then remove the rear caliper body (A). Tightening torque: 21.6 ~ 31 ...

Evaporator Temperature Sensor Inspection
1. Turn the ignition switch OFF. 2. Disconnect the evaporator temperature sensor connector. 3. Measure resistan ...

Categories

Copyright © www.kirmanual.com 2014-2026