Kia Rio: SS-A Solenoid Valve(ON/OFF) Inspection

1.	Turn ignition switch OFF.

2.	Disconnect the solenoid valve connector.

3.	Measure resistance between sensor signal terminal and sensor ground terminal.

4.	Check that the resistance is within the specification.

SS-A Solenoid Valve(ON/OFF) Circuit Diagram

...

SS-A Solenoid Valve(ON/OFF) Removal

1. Remove the battery and the battery tray. (Refer to "Charging system" in EE group.) 2. Remove the under cover (A). ...

See also:

SRS Control Module (SRSCM) Installation
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes before beginning ...

Specification
Pressure [kPa (kgf/cm², in H2O) Output Voltage (V) -6.67 (-0.068, -26.8) 0.5 0 2.5 +6.67 (0.068, 26.8) 4.5 ...

Circuit Diagram
...

Categories

Copyright © www.kirmanual.com 2014-2026