Kia Rio: Inhibitor Switch Removal
| 1. |
Place the shift lever into the "N" position.
|
| 2. |
Remove the air cleaner assembly.
|
| 3. |
Remove the battery and the battery tray.
(Refer to "Charging system" in EE group.)
|
| 4. |
Disconnect the inhibitor switch connector (A).
|
| 5. |
Remove the shift cable mounting nut (B).
|
| 6. |
Remove the manual control lever (B) and the washer after removing
a nut (A).
|
| 7. |
Remove the inhibitor switch (A) after removing the bolts (2ea).
|
Inhibitor Switch Installation
1.
Check that the shift lever is placed in the "N" position
2.
Install the inhibitor switch (A).
...
See also:
Precautions
General Precautions
Please read the following precautions carefully before performing the
airbag system service.
Observe the instructions described in this manual, or the airba ...
Curtain Airbag (CAB) Module Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least thirty
seconds.
...
Description
Knocking is a phenomenon characterized by undesirable vibration and noise
and can cause engine damage. Knock Sensor (KS) is installed on the cylinder
block and senses engine knocking.
Whe ...
Categories
- Kia Rio Manuals Home
- Kia Rio YB 2017-2025 Owners Manual
- Kia Rio YB 2017-2025 Service Manual
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright www.kirmanual.com 2014-2025