Kia Rio: TPMS Receiver Operation
|
1. |
General Function
| A. |
Auto-learn takes place only once per Ignition cycle.
|
| B. |
On successful completion, 4 road wheel sensor ID's are
latched into memory for monitoring.
|
| C. |
Until Auto-learn completes, previously learned sensors
are monitored for under inflation / leak warnings.
|
|
|
2. |
General Conditions to Learn New Sensors:
| A. |
Receiver must determine that it is confident that sensor
is not temporary:
|
| 2) |
Uses confidence reduction of previously learned
sensors.
|
|
| B. |
Typical time at driving continuously over 12.4 mph(20
kph) to learn a new sensor is up to 20 minutes.
|
|
|
3. |
General Conditions to Un-Learn a sensor that is removed:
| A. |
It takes less than 20 minutes at 12.4 ~ 18.6 mph(20 ~
30kph).
|
| B. |
Confidence reduction is dependent on time which vehicle
is driven at speed greater than or equal to 12.4 mph(20 kph).
|
|
1.
Mode
(1)
Virgin State
A.
The receiver as a sole part is shipped in this
state. ...
When the receiver first arrives for replacement:
1)
It will be in Virgin State.
...
See also:
Inspection
Clutch Pedal Inspection
1.
Measure the clutch pedal height (from the face of the pedal pad
to the floorboard) and the clutch pedal clevis pin play (measured at
the ...
Starter: Inspection
Starter Solenoid Inspection
1.
Disconnect the lead wire from the M-terminal of solenoid switch.
2.
Connect the battery as shown. If ...
Removal
Rear Disc Brake Type
The parking brake cables must not be bent or distorted. This will
lead to stiff operat ...
TPMS Receiver Description
TPMS Receiver Replacement