Kia Rio: Steering Column and Shaft Disassembly - Electric Power Steering - Steering System - Kia Rio UB 2012-2026 Service ManualKia Rio: Steering Column and Shaft Disassembly

Key lock assembly
1.
Make a groove on the head of special bolts (A) with a chisel.


2.
Loosen the special bolt using a screw driver and then remove the key lock assembly from the steering column assembly.
3.
Reassembly is the reverse of the disassembly.
Universal joint assembly
1.
Loosen the bolt (A) and then disconnect the universal joint assembly from the steering column assembly.

Tightening torque :
27.5 ~ 29.4N.m(2.8 ~ 3.0kgf.m, 20.3 ~ 21.7lb-ft)


2.
Reassembly is the reverse of the disassembly.

     
Do not disassemble the EPS module from the column shaft.
Steering Column and Shaft Replacement
1. Disconnect the battery negative cable from the battery and then wait for at least 30 seconds. 2. Turn the steering wheel so that the fro ...

Steering Column and Shaft Inspection
1. Check the steering column for damage and deformation. 2. Check the steering column for damage and deformation. 3. ...

See also:

Shift Lever Adjustment
Adjusting the control cable 1. Set room side AT lever(shift lever) and automatic transaxle side manual control lever to "N" position. ...

Sunroof Motor Replacement
1. Disconnect the negative (-) battery terminal. 2. Remove the roof trim. (Refer to the BD group - " Roof trim") ...

Roll Over Valve (ROV): Repair procedures
Removal 1. Remove the fuel pump. (Refer to Engine Control/Fuel System - “Fuel Pump”) 2. Remove the roll over valve (A) after relea ...

Copyright www.kirmanual.com 2014-2026