Kia Rio Manuals

Kia Rio: Front Impact Sensor (FIS) Installation - SRSCM - Restraint - Kia Rio UB 2012-2026 Service ManualKia Rio: Front Impact Sensor (FIS) Installation


     
•
Do not turn the ignition switch ON and do not contact the battery cable while replacing the front impact sensor.
1.
Install the new front impact sensor.
2.
Tighten the front impact sensor mounting nut.
Tightening torque :
7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)
3.
Connect the front impact sensor connector.
4.
Left side - Install the air duct assembly.
Right side - Install the washer reservoir.
(Refer to the Body Electrical group - "Washer motor")
5.
Install the front wheel guard.
6.
Reconnect the battery negative cable.
7.
After installing the Front Impact Sensor, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
Front Impact Sensor (FIS) Removal
   • Removal of the airbag must be performed according to the precautions/ procedures des ...

Side Impact Sensor (SIS) Description
Side Impact Sensor (SIS) system consists of two P-SIS which are installed at each center of the front door module (LH and RH) and two SIS which are installed at each center pillar nearby (LH ...

See also:

Installation
   • Install the component with the specified torques. • ...

Installation
1. Install in the reverse order of removal. Battery (-)terminal installation [with battery sensor] : 4.0 ~ 6.0 N.m (0.4 ~ 0.6 kgf. ...

Front Wheel Speed Sensor Components
1. Front wheel speed sensor connector 2. Front wheel speed sensor ...

Categories

Copyright www.kirmanual.com 2014-2026