Kia Rio Manuals

Kia Rio: Passenger Airbag (PAB) Module Removal - Airbag Module - Restraint - Kia Rio UB 2012-2026 Service ManualKia Rio: Passenger Airbag (PAB) Module Removal

1.
Disconnect the battery negative cable and wait for at least thirty seconds before beginning work.
2.
Remove the glove box housing.
(Refer to the Body group - "Crash pad")
3.
Disconnect the passenger airbag connector (B) and remove the PAB mounting bolt (A).
4.
Remove the crash pad.
(Refer to the Body group - "Crash pad")

     
If the PAB has been deployed, replace the damaged crash pad.
5.
Remove the heater duct from the crash pad.
6.
Remove the mounting bolts from the crash pad. And then remove the passenger airbag.

     
The removed airbag module should be stored in a clean, dry place with the airbag cushion up.
Passenger Airbag (PAB) Module Components
...

Passenger Airbag (PAB) ModuleInstallation
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable from battery and wait for at least thirty seconds bef ...

See also:

Steering Column and Shaft Adjustment
After or before servicing the EPS system, perform the troubleshooting and test procedure as follows. Compare the system condition with normal condition in the table below and if abnormal symp ...

Components
1. HECU module 2. Front wheel speed sensor 3. Rear wheel speed sensor 4. Yaw rate & G sensor 5. Steering angle sensor 6. ABS Warning lamp 7. Parking brake/EBD warn ...

SS-B Solenoid Valve(ON/OFF) Removal
1. Remove the battery and the battery tray. (Refer to "Charging system" in EE group.) 2. Remove the under cover (A). ...

Categories

Copyright www.kirmanual.com 2014-2026